The control device

Easy operation by the buoyant hand-control with emergency stop.

Optimal security - with insufficient power the lowering of the lift is not possible - raising however is ensured at any time .

The hand-control is connected with the control unit by a cable and contains all controls:

- to the right, a green key for the upward movement.
- to the left, a green key for the downward movement.
- in the center, a red key for the EMERGENCY STOP.

Due to the circuit arrangement the lift can only move while one of the two green keys is pressed.

If the pressed key is released, the movement stops immediately.

If the battery is not sufficiently charged for a complete bathing process, the lift can no longer be driven downward. However, the lift can always be driven upward, to make it possible to get out of the tub.

By pressing the red EMERGENCY STOP key all functions of the lift are suspended immediately.

To resume the function - release the red key - press the green key (for safety reasons it is only possible to move in opposite direction).

Those parts of the hand-control which are under power are protected against water penetration by a seal. The hand-control is buoyant and can be put into the water.

In the center between the three keys there is a red control light.
A solid red light indicates a dead battery.
Upward movement is still possible. The battery must be charged.

Adjustment of the backrest

The backrest can be adjusted either in the initial position 'seat unit down on the bottom of the tub' (preferrably) or in the upmost position.

Convert to lying position:

Hold neck support tight and pull side flap slightly upward . The backrest locks into the correct position.
Drive lift upward to begin bathing process .

Back to seating position:

Pull side flap slightly upward.
Lean the neck support forward and shift it with light pressure towards the seat into locking position.
The lift is then in the seating position.